TasmanEco Aspley Cot, Assembly And Care Instructions

Page: 5 / 12

5
COT
BASSINE
T
COT
BASSINE
T
Assembly overview
Before commencing
assembly, note that
Aspley cot can be
assembled as a full cot,
with the base set in the
lower position; or as a
bassinet with the base
set in the high position.
Cot Bassinet
Step 1 - Attach the side panels to the base
A). Attach each side panel to
the base. Note the base position
needed for either ‘cot’ or ‘bassinet’
configurations.
To secure the base rails: Insert a lunar
washer to the locating hole at each
end of the base rails and then insert
the connector screws and lightly hand
tighten each connector screw.
Do not fully tighten the screws at this
time.
B). IMPORTANT SAFETY STEP
Fit the small cap screws to the 4
remaining unused base locating holes
(2 on each side). This is a required
safety step to prevent the entry of
small fingers into these holes.
Hardware needed
4 x 55mm connector screws
4 x 15mm cap screws
4 x lunar washers
A.
B.
x4