TasmanEco Aspley Cot, Assembly And Care Instructions, Page: 6 / 12

6
Step 2 - Attach the front and rear fixed panels
Gently spread the side panels
apart to allow sufficient
clearance for the fixed panels
to placed in position without
damaging the surfaces of the
panels.
Note the correct orientation of
the panels; the metal badges
must face outwards on both
panels.
Position the fixed panel
between the side frames and
align the locating holes for the
connector screws.
Insert the connector screws
to both ends of the fixed
panel. Lightly hand tighten the
connectors screws - but do not
fully tighten at this time.
Repeat the above steps for the
remaining panel.
Hardware needed
x8
8 x 55mm connector screws
Note the correct
orientation of the
panels; The metal
badge must face
outwards on both
panels.