28
Using the Manual Drive mode, position the machine at the
cleaning start location. The machine must be located within
2 ft (61 cm) of start location shown on cleaning pattern.
To enable Area Clean, perform the following from the home
screen:
Press the Area Clean button and choose an
area cleaning pattern.
GO
Press the GO button and the machine will
begin robotic cleaning.
After the GO button is pressed the machine will spend a few
moments calculating the cleaning plan before proceeding
robotically. The machine will continue to clean until it reached
the end of the cleaning pattern.
To interrupt the cleaning pattern, press the
PAUSE button.
GO
To resume the cleaning pattern after a
pause, press the GO button.
To terminate the cleaning pattern, press the STOP button.
On the first pass of the cleaning area, the machine is looking
for openings that match the selected pattern. If the openings
are not found, the machine will stop.
If the machine finds a partial match, it will clean the area
corresponding to the map and then stop.
26.3. Map Clean
Map Clean utilizes custom cleaning patterns created and
downloaded to the machine by authorized operators. To
enable Map Clean:
Using the Manual Drive mode, position the machine at the
cleaning start location. The machine must be located within 2
ft (61 cm) of the start location shown on the cleaning pattern.
Press the Map Clean button and chose a
custom cleaning pattern.
GO
Press the GO button and the machine will
begin robotic cleaning.
After the GO button is pressed the machine will spend a few
moments calculating the cleaning plan before proceeding
robotically. The machine will continue to clean until it reached
the end of the cleaning pattern.
To interrupt the cleaning pattern, press the PAUSE button.
GO
To resume the cleaning pattern after a
pause, press the GO button.
To terminate the cleaning pattern, press the STOP button.
On the first pass of the cleaning area, the machine is looking
for openings that match the selected pattern. If the openings
are not found, the machine will stop.
If the machine finds a partial match, it will clean the area
corresponding to the map and then stop.
27. Daily Shutdown Procedure
After completing cleaning, the following steps should be
performed daily:
Use of protective glasses, gloves, and
apron is recommended when in contact with
waste water or cleaning any element of the
system.
27.1. Parking
Use manual drive to position the machine next to the
disposal area.
Ensure the scrubber is turned off and the scrubber heads are
in the up position.
Ensure the vacuum is off and the squeegee is in the up
position.
Place the parking brake in the locked position by moving the
red lever to the left.
Figure: 54
Turn off the system by pressing and holding
the standby button.
27.2. Drain and Clean the Tank
Before draining the tank, take note of any
local or national regulations for disposal.
Waste water must be disposed of in a
responsible manner, consistent with
applicable environmental and safety
regulations.
Locate the drain hose, remove the end
from the holder and position the drain hose
over the disposal area.
Pull the drain valve and drain the waste
water into the disposal area.
Clean out debris and sediment from the
basket filter and bottom of tank.
