TASCAM MZ-372
11
h
C (MONO)
/MIC input jacks
These are analog XLR input jacks (1: GND, 2: HOT,
3: COLD).
Their input gains can be adjusted using the
GAIN
(
4
) knobs on the front of the unit.
j
INPUT LEVEL switches
Use these to set the input levels of the input sourc-
es (mic or line) connected to the
C (MONO)
/MIC
(
h
) input jacks.
Set to
MIC
for mic level signals, and set to
LINE
for
line level signals.
k
LINE/PHONO input selection switches
For channels 2–4, if the output of a CD player or
similar device is connected to a
LINE
A
input (
v
)
jack, set this to
LINE
. If a record player output is
connected, set it to
PHONO
.
l
Cord holder
Attach the power cord of the included AC adapt-
er (TASCAM PS-M1524) here to prevent accidental
disconnection. (See “Attaching the cord” on page
;
DC IN 15V connector
Connect the included AC adapter (TASCAM PS-
M1524) here.
z
MONITOR OUT jacks
These RCA pin jacks are analog monitoring out-
puts.
x
SUB OUTPUT jacks
These RCA pin jacks are analog outputs.
Mono signals will be output if the
SUB OUTPUT
(
d
) switch is set to
MONO
.
c
MAIN OUTPUTS 1-2 (BALANCED) jacks
These analog outputs are XLR jacks. (1: GND, 2:
HOT, 3: COLD)
Use the
ATTENUATOR
(
g
) switches to change the
output levels.
v
LINE A/B input jacks
These RCA pin jacks are analog line outputs.
Record players can be connected to the
LINE
A
input jacks of channels 2–4. When connecting
a record player to these jacks, also connect its
grounding wire to the
|
(GND) jack (
b
), and set
the
LINE/PHONO
input selection switch (
k
) to
PHONO
.
b
|
(GND) connectors
If a record player is connected to the
LINE A
input
(
v
) jacks of channel 2–4, also connect its ground-
ing wire to this.
NOTE
If a humming noise occurs when connecting a
device other than a record player, connecting
a grounding wire from the metal frame of that
device (or the rack frame if rackmounted) to this
could reduce the noise.
Preparation
Connecting the power
Use the included AC adapter (TASCAM PS-M1524) to
connect a power supply to the unit as shown below.
Power outlet
DC plug
TASCAM
PS-M1524 (included)
CAUTION
Always use the AC adapter (TASCAM PS-M1524)
that was packaged with the unit. Using a different
AC adapter could cause malfunction, overheating,
fire or other problems.
NOTE
The AC adapter for the unit includes two types of
adapter cords. Attach the type of AC adapter cord
that matches the power outlet that you are using.
Attaching the cord
In order to prevent the cord from becoming discon-
nected during use, attach it to the cord holder (
l
)
when connecting it to the unit.
1.
Remove the cord holder (
l
) screw.
2.
Place the cord in the cord holder (
l
).
3.
Tighten the cord holder (
l
) screw.
