Tarrington House MAC2320C, Instruction Manual

Page: 8 / 218

- 8 -
GB
Problem
Possible
cause
Solution
Air
conditioning/
heating mode
is active,
but cooling/
heating effect
is insufficient.
Wrong
temperature
setting.
Set a
temperature
that is lower/
higher than
the ambient
temperature.
Air filters are
blocked by
dust.
Clean the air
filters.
Air inlets or air
outlet blocked.
Remove the
obstruction.
The appliance
is placed in a
very hot/cold
room.
Allow the
appliance to
work longer
to achieve
the desired
temperature.
Cooling/
heating
capacity of
appliance is
insufficient
for area it is
placed in.
The appliance
can cover
an area of
max. 15m 2
(MAC2320C),
18m 2
(MAC2540C)
or 23m
2
(MAC3540C).
To cover a
larger area,
a bigger or
an additional
appliance is
needed.
Doors or
windows are
open.
Close all doors
and windows.
If the appliance
was installed
in an open
window, close
the window a
far as possible.
Appliance
is noisy or
vibrates.
Appliance was
not placed on a
proper surface.
Place the
appliance on a
firm, level and
stable surface.
pull out the filter from the cover. After cleaning,
reinstall it in its cover and reattach the cover to
the appliance.
• If the display shows “P1” or if you don’t want to
use the appliance for a longer time, drain the
water from the bottom outlet. For this, open the
outlet, tilt the appliance a little and let the water
run out. Afterwards, close the outlet, restart
the appliance and wait until the “P1” indicator
disappears from the display.
• The appliance may only be used again or stored
after it is dried completely.
6. Troubleshooting
Problem
Possible
cause
Solution
Appliance does
not operate.
Power plug
not connected
to electrical
outlet.
Connect
power plug
to a suitable
electrical outlet.
Plug it in tightly.
Supply cord is
damaged.
Have supply
cord replaced
by the
manufacturer,
its service agent
or similarly
qualified
persons.
Appliance
has just been
switched off
and cannot
restart
immediately.
Wait for 4
minutes before
pressing the
On/off button
again.
Room
temperature is
lower than set
temperature
in cooling
mode or
higher than set
temperature in
heating mode.
Set a lower/
higher
temperature.