+
Configurar
1X = Desabilita
2X = Liga s/ Trava
3X = Liga e Trava
4X = Liga e trava
desliga e destrava
+ +
IGNIÇÃO
ON
START
OFF
MASTER
PORTA ABERTA
Selecionar a função Beep 16
+ +
IGNIÇÃO
ON
START
OFF
MASTER
PORTA ABERTA
Selecionar a função Beep 15
To change, press the Master key the number of times referring to the desired
function. Each time you press the Master, the alarm confirms with 1 beep.
After turning the ignition off , the alarm will confirm the new setting with
beeps.
+
MASTER
4 Beeps
= Turns On and Lock s/ Turns Off and Unlocks
- With the door open, switch on the ignition.
Programming by Master
- The alarm responds with the current setting:
2 Beeps
= Turns on the alarm without locking
- Hold the master pressed until beep 16.
3 Beeps
= Turns on the alarm and locks
16) Turn Alarm on by distancing:
This function is used to turn on the alarm only when pulling the TR2-P G4 remote control away
from the vehicle.After turning off the ignition, opening and closing the vehicle door, and
moving the control beyond the transmission range, within 15 seconds the alarm will turn on.
According to the setting the alarm will:
1st Beep =
Disabled, the alarm will only turn on/off when pressing the Control Buttons.
2nd Beep =
Turns on the alarm by moving the control away without locking the doors, it will
only turn off the alarm by pressing the control's Off button.
3rd Beep =
Turns the alarm on by pulling the control away and locks the doors, it will only turn
off the alarm and unlock the doors by pressing the Off button on the control.
4thBeep =
Turns the alarm on by pulling the control away and locks the doors. Turns off the
alarm and unlocks the doors by pressing the control's Off button or by bringing the TR2-P G4
control closer to the vehicle and waiting for the automatic transmission.
ATTENTION: EXCLUSIVE function of the TW20 and TW30 G4 range with TR2-P G4 control.
15) Open and Close Automated Gate -
exclusive to TW30 G4
Installation:
- Clone the original gate control in the TW30 G4 central.
Attention: Function compatible only with operators that use the CODE LEARNING code
system.
Operation:
With the ignition on, doors closed, press the high beams key (flasher) twice to open or close the
gate.
- Connect the MR wire to the high beam flasher signal.
It is not necessary to do any type of programming in the gate operator central.
Programming:
- With the door open, turn the ignition on.
- Hold the master pressed until beep 15.
When releasing the master, the siren will sound a long
beep.
- Hold pressed the button that opens the gate until the
alarm beeps 3, confirming the recording.
- Turn off the ignition to exit programming.
+
Clone
17
