Taramps TW 30 G4, Manual

Page: 13 / 19

- The alarm will respond informing the current setting:
1 Beep = Sensitivity
+20%
- With the door open, turn the ignition on.
- Hold the master pressed until beep 12.
2 Beeps = Sensitivity +10%
Set Ultrasound Sensitivity
5 Beeps = Sensitivity -20%
3 Beeps = Sensitivity Standard
4 Beeps = Sensitivity -10%
To change, press the Master key the number of times referring to the
desired sensitivity. Each time you press the Master, the alarm confirms with
1 beep. After turning off the ignition, the alarm will confirm the new setting
with beeps.
+
MASTER
+
Configure
1X = +20%
2X = +10%
3X = Standard
4X = -10%
5X = -20%
+ +
IGNITION
ON
START
OFF
MASTER
DOOR OPEN
Select the Beep 12 function
Click
1 Time
2 Times
3 Times
4 Times
5 Times
Alarm Response
Sensor Sensitivity
+20%
+10%
Factory Standard
-10%
-20%
1 Beep
2 Beeps
3 Beeps
4 Beeps
5 Beeps
Decrease
Increase
Table Follows below:
Fix the sensors to the vehicle's windshield, 10cm below the roof.
Ultrasound Sensors come with digital sensitivity adjustment.Only
change the default setting if necessary.
New Transmitter*
(See page 10)
12) G2 Ultrasound Sensors
13
12.1) LED Functions
LED FLASHING NORMALLY - Alarm on;
LED FLASHES 2X - Alarm on with cancelled ultrasound sensor;
LED ALWAYS ON - Door, Hood or Trunk open;
Indicates which sensor caused the last alarm trigger:
-1 flash - ignition
-3 consecutive flashes- doors, hood or trunk.
- 2 consecutive flashes- ultrasound sensor.
LED OFF - Alarm off;
LED FLASHING AFTER TURNING ALARM OFF BY REMOTE CONTROL