Safety requirements
Introduction
Taramps reserves the right to modify the contents of this document at any me without prior no ce and does not
have the obliga on to apply the changes in units which were previously produced.
-
Never install the product in places exposed to dust, humidity and water. Pay attention to install
it far from fuel tank, fuel lines, heat sources and other parts of vehicle.
-
Be sure to install protection fuse or a circuit braker near to battery. Follow the ampere rating as
indicated here in this manual. Use of improper fuse or circuit breaker could result in overheat,
smoke, damage to product, injury or burns.
-
When in use, the external surface of may amplifier becomes hot. Avoid touching the heatsink
area and keep childrens far from the amplifier.
-
This product may produce high sound pressure levels. Avoid continuous exposure to levels
over 85dB to prevent permanent hearing loss.
-
Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect
any wires routed through car's body.
-
Before make any connection to amplifier, disconnect the battery negative terminal.
-
Output connections for speakers may have voltage levels when the amplifier is operating.
Make sure that the system is turned OFF before proceed any connection or disconnection in this
terminals.
To ensure proper use, please read through this manual before using the amplifier. It is specially
important that you know the
WARNINGS
and
CAUTIONS
contained here.
-
The installation of this product must be done by a qualified professional.
-
Wear safety glasses, insulated gloves and correct tools for installing this product.
-
This product is for use with 12V batteries. Always check the voltage before installing.
-
This product must be installed in a firm place with at least 1” space around the heasink for
proper heat spreading.
As you read this manual, pay attention to the safety symbols.
Safety
This symbol with
“CAUTION”
is intended to alert the user to the presence of
important instructions. Failure to heed the instructions will result in risk of
injury to user or product damage.
CAUTION
Read this manual before installing the product. In case of
questions contact our technical support:
+55 (18) 3266-4050
or
www.taramps.com.br.
At the end of its lifespan, this product must not be
disposed of in household waste. Look for an
electronic equipment collection or recycling center
for proper disposal.
02
The wire gauge for power supply connections is 1,5mm² (15 AWG) for positive and negative
wires, and 0,50mm² (20 AWG) for remote signal wire.
For protection against overload, install a fuse on positive wire, close to battery terminal (1A). See
page 12.
1 - Power supply negative: Connect to negative pole of battery.
2 - Remote signal input: Connect to remote signal output from head unit.
3 - Remote ouput:
For connection in amplifiers
4 - Powe supply positive: Connect to positive pole (12V) of battery.
Key recommendations
