TARAL 850, Instruction Manual

Page: 79 / 102

HEADLAMPS
Perform periodic maintenance in order not to disturb
other drivers when using the front head lamps of the
tractor on roads, and to comply with the laws and
regulations.
Your tractor is equipped with a proper head lamp in
accordance with the local and country laws and
provides suitable head lamp alternatives for right-
and left-hand traffic patterns.
Adjustment of the front head lamps is a device
requiring procedure; we recommend you to visit your
dealer.
Illumination adjustment of the front head lamps can
be performed alternatively as follows:
1. Pull your tractor over on a smooth surface next
to a white wall with head lamps positioned as
nearest as possible to the wall, after loads and
weights are disconnected and the tires are
adjusted to the recommended road pressure.
2. Turn on the head lamps and draw a line on the
wall right through the middle of the highest and
lowest point illuminated by the head lamps. Now
draw a vertical line on the wall towards to
ground at the level aligned with the center of the
tractor.
3. Pull the tractor 5 meters backwards.
4. Illumination cone of the head lamps must collide
with the line drawn on the wall. Maximum
variation may be 130 mm.
5. For each head lamp, the distance between the
refraction on the illumination cones and vertical
line must be equal. Maximum variation may be
50mm.
6. If the adjustments above is not proper, adjust by
tightening/loosening the screws (1) shown in
“Figure 76”. These screws are on the back of the
head lamps; you must open the bonnet first.
TRAILER PLUG
There is a 7 terminal plug at the tractor. Location
of pins and the terminal connection of the plug are
as follows:
1. Right Hand-Side Turn Signal
2. Chassis
3. NEUTRAL
4. Left Hand-Side Turn Signal
5. Brake
6. Parking
7. NEUTRAL
ILLUMUNATION LAMPS
The specifications for the bulbs used in illumination
lamps are as follows:
Front head lamp: 12V 55/60W bulbs, double
filament each
Front parking lambs, 12V 5W bulbs each
Front signal lambs, 12V 21W bulbs each
Rear parking lambs, 12V 5W bulbs each
Rear signal lambs, 12V 21W bulbs each
Braking lambs, 12V 21W bulbs each
Rotating beacon lamp 12V 55W bulbs
Plate lightning 12V 4W bulbs
If the bulbs are burn, contact your dealer for
replacement.
WARNING
Figure 76
1
Figure 77
67