401 Jeffreys Road
Rocky Mount, NC 27804
Tel: 252-442-0700
7.2.
Machine Lubrication
Appropriate periodical maintenance works considerably decrease the wear and tear of
mating components and additionally protect against corrosion.
You should lubricate all the lubrication points enumerated below. The lubrication should be
performed with use of a greaser. Before commencement of lubrication works, the point to be
lubricated should be cleaned from any dirt and residues of previous grease layers and the
grease fitting should be checked to be sure it is not damaged. Replace the fitting if it is
damaged. After the lubrication has been performed, excessive grease should be removed. It
attracts dirt and contaminants.
All maintenance and servicing works should be done with the switched off
engine of the vehicle, released pressure and stopped rotations, and with
both, the vehicle and machine. properly secured.
Avoid contact with oil!
Use the personal safety gear: protective clothing, footwear, gloves, and
goggles.
The power take-off shaft (PTO) should be operated and lubricated by using
operating instructions provided by the manufacturer of the shaft.
No.
Lubrication points
Description
Greasing frequency
Type of Lubrication
1
Main gear
1.
Filler plug
2.
Drain plug
The oil should be
replaced after the
initial 50 hours of
operation then every
600 operating hours or
at least once a year.
Oil-SAE90EP-
ISO VG 320-1.2l
2
Side Gear
400 hours or at least
once a year
NLGI 2 SHELL
Gadus S2 V220 -
0.2kg