401 Jeffreys Road
Rocky Mount, NC 27804
Tel: 252-442-0700
Any preparations, fitting, dismantling or adjustment can be performed only after the
drive has been switched off, the engine stopped, the vehicle immobilized and when all
the moving parts of the machine have stopped.
You should always determine the same driving direction for each wheel!!!
The handle block must always be in the locking sleeve hole!!!
Free wheel operation - FORBIDDEN!!!
6.6.4.
Additional operation angle adjustment
The machine is equipped with the angle change, distance of the green fodder discharge
through the change of the wheel bow fastening.
To this end, the wheel bow should be fastened in
the upper hole (
Fig. 15
1st pos.) or lower (
Fig. 15
pos.
2). Remember that the change of the wheel
bow fastening results in the change of ground following quality - this relates to the change of
the wheel axle position towards the machine frame axle.
Normally, the fastening is done in the middle hole. This ensures sufficient spreading and
excellent ground following.
Fig.15
Additional operation angle adjustment