21
Rear Panel
9. INPUT
These are Neutrik combo connectors, which accept balanced
microphone inputs from an XLR connector, or balanced or unbalanced
line-level or instrument-level inputs from a 1/4" TRS connector.
The XLR inputs are wired as follows:
Pin 1 = Shield or ground
Pin 2 = Positive (+ or hot)
Pin 3 = Negative (– or cold)
The 1/4" inputs are wired as follows:
Sleeve = Shield or ground
Tip = Positive (+ or hot)
Ring = Negative (– or cold)
10. PHANTOM 48V Switch
Push this button in if you are using a microphone that requires 48
VDC phantom power. This applies phantom power to pins 2 and 3 of
both XLR inputs. It has no effect on the 1/4" inputs.
Note:
There are just a few microphones (mostly ribbon
mics) that can be damaged by phantom power. Consult
your microphone’s owner’s manual to see if it needs it or
not. If it does, always turn off the phantom power switch
before connecting or disconnecting your microphone.
11. LEFT/RIGHT MONITOR Out
These 1/4" TRS connectors provide a balanced stereo line-level
output of the monitor mix. Connect these outputs to a pair of active
monitor speakers. or to an amplifier connected to passive speakers. The
signal level is controlled by the MONITOR LEVEL control [4] on the front
panel.
MONITOR
INPUT
INPUT
USB
PHANTOM
+48V
LEFT
RIGHT
1
2
9
12
10
11
13
