INSTALLATION AND ASSEMBLY
3.3 Turnstile hub assembly
There should be no power in the turnstile during the assembly process.
Figure 3.8 Hub assembly
The image shows the LTT 303 model turnstile, but all of our tripod turnstile hubs are
assembled in the same way. Turnstiles are delivered from our factory as assembled. The turnstile
hub consists of 6 parts in total.
(Figure 3.8)
Assembling and disassembling are very easy. Follow
the steps for assembly:
Screw the screw (no. 1) and the screwing disc (no. 2) into the mechanism through the wedge
hole in the mechanism. When this screw is tightened, there should be no power in the turnstile, and
it must be locked in both directions as the mechanism will rotate from the inside. When there is no
power, the locking tabs can also be held by hand.
Place any of the holes in the arm hub (no. 3) so as to pass through the screwing disc. Please
note that the arm hole on the hub should face upwards. Pull the correctly placed hub from screws
(no. 5) and washer group (no. 4), and firmly screw it to the screwing disk. The connection of the
hub to the mechanism is completed, and the process over after placing the hub stopper (no. 6).
Disassemble: Follow the assembling order in reverse.
| 16 |
