Setups
General Setup Procedure
}
Decide which Setup you are going to build.
}
Connect the Ellipse iDP
™
monitors exactly as shown on the following pages.
}
Power up all monitors.
}
Set one of the Master-monitors as the System Controller as shown on the Setup diagrams. Leaving the TC LINK
button on the rear panel on the OUT position does this.
}
NOTE: There can be only ONE System Controller in a setup.
}
After “power-up” the System scans all connected monitors every 5 seconds.
Set tasks for all monitors from the System Controller (unless you have iDP SOFT
™
* or PC-iP
™
**)
}
Enter Setup menu by pressing ENTER, ARROW DOWN, ENTER.
}
Select the setup type you are using.
}
Press ENTER again and the System will generate Pink Noise in one of the monitors.
}
Select appropriate task for the monitor currently fed with Pink Noise using the ARROW keys and press ENTER
to confirm.
}
Continue allocating tasks for all monitors in the system.
Your monitor system is now set up ready for calibration and fine-tuning.
* iDP SOFT
™
is explained later in this Manual
** Ellipse iDP PC-iP
™
has it’s own dedicated user manual
Analog Stereo Set-up With Mono Sub(s)
The diagram shows how to connect a stereo set-up with
one subwoofer. If you are using a standard stereo set up
(no subwoofer) then simply omit the subwoofer.
}
The Left monitor is set as the System Controller by
leaving out the TC Link button on the rear panel.
}
The Left master monitor receives both the left and
right input signals via the analog input connectors.
}
The Right monitor and Sub receive audio and control
via the output RJ45 TC Link connections on the Left
(system controller) monitor.
}
When no Bass management is selected, no signal
will be sent to the subwoofer.
}
When Bass management is selected, low frequency
content from the left and right channels is extracted
and sent to the subwoofer.
}
The iDP
™
Remote, iDP SOFT
™
or PC-iP
™
can be connected
to any spare TC Link “out” connection.
}
! REMEMBER – To set a master monitor as the system
controller the TC Link button on the rear panel
MUST be in the out position.
16
Summary of Contents for Ellipse 8 iDP
Page 1: ...Owners Manual TM ...
Page 2: ......
Page 48: ...48 Dimensions Ellipse TS212 iDP Grey Silver 520mm 20 47 490mm 19 29 498mm 19 6 ...
Page 55: ......
