TANDBERG TR-2075, Operating Instructions Manual

Page: 9 / 24

9
Tuning on AM
Select AM reception by depressing the AM button. The red
light over the button will light telling you that the receiver is
in the AM mode. Use the large tuning knob on the right side
of the scale to tune in the required station. Tune for
maximum deflection on the SIGNAL meter.
NOTE! Make sure that the PREAMP REC
button is released.
Volume-Balance
Use the VOLUME knob to control the audio power fed to the
loudspeakers. Use the BALANCE knob to control the relative
output levels from the two speaker channels. A typical use for the
BALANCE control is to compensate for differences in the
characteristics or the positioning of left and right speakers.
Tone Controls
This receiver is equipped with three independent tone controls for
controlling the BASS, 'PREBLE and MIDRANGE audio
frequencies. The effects that can be achieved when these three
controls are used may be seen in the graphs.
The knobs are the split type where the inner part of the knob is for
the right channel and the outer part of the knob is for the left
channel.
Tone controls can be used to achieve a tone picture that is pleasing to
the individual listener. They can also be used to compensate for lack
of "body" in any particular tone region with a program from any
source. A further use for tone controls is to compensate for speakers
and/or room acoustics that do not. give the desired tone picture,
Other controls affecting the tone response are LOW FILTER, HIGH
FILTER 1, HIGH FILTER 2
and LOUDNESS (see page 11).