Sequential Mode
— Applies when the Loader Mode is set to Sequential. When
Normal is selected, sequential operation terminates after the last cartridge in the
sequence has been unloaded. A cartridge sequence ends at an empty slot or when the
cartridge in slot 8 has been unloaded. (Slot 7 if Cleaning Slot is enabled)
When Recirculate is selected, operation continues with the first cartridge in the
sequence. This option does not display unless you have selected Sequential Mode in
the Loader Mode option.
Baud Rate
— Sets the trace serial port baud rate. Allowable values are:
•
2,400
•
9,600
•
19,200
•
38,400
•
57,600
•
115,200 (Default).
Enable Bar Code
— Enables the bar code reader. When the reader is enabled,
the barcode of the cartridge in each occupied magazine slot and in the drive (if any)
will be scanned during the Inventory process.
Enable Check Char
— Enables the check sum character to be used to verify the
correctness of each bar code label scan. Does not display unless you have enabled
the bar code reader in the Enable Bar Code option.
Cleaning Slot
— If enabled, dedicates slot 8 to cleaning operations.
Note:
Do not insert the cleaning cartridge in any other slot than slot 8.
Set Serial Number
— The 12-character string of the assigned serial number
entered using the control panel and buttons.
Tandberg SLR Autoloader Service and Repair Manual
44