Tandberg Data
Chapter 2 - Installation
Removing the Locking Pin
To remove the locking pin (also called lockdown mechanism), do the following:
1. Make sure that the power cord is disconnected from line power.
2. Place the unit on a table at waist height.
3. Position the unit so that the front panel door is facing toward you.
4. Rotate the unit onto its left side so that the bottom of the unit faces right and
its rear chassis end points away from you.
5. Remove the screw from the locking pin as shown in the following
illustration:
6. Pull the locking pin out slowly. It should come out easily. If it doesn’t,
remove the magazine and investigate the internal shuttle area through the
front panel door with a flashlight. (See
Appendix C
for instructions on
opening the door without power.) Make sure that the pin is not bent. If it is,
contact Tandberg Data for instructions on removing the pin or returning the
unit to Tandberg Data for repair or replacement.
7. Save the locking pin (6.6” / 16.8 cm) and its screw (M3x8 Phillips panhead)
in case you must return the unit to Tandberg Data. These two parts
must be
installed
when shipping the unit back to Tandberg Data.
Tandberg SLR Autoloader Service and Repair Manual
17
Right Side View with
Chassis Panel
Removed
Right Side View, Rotated 45
°
Upward with Chassis Panel
Removed
Locking Pin (Installed)
Metal Tab on Locking Pin
Screw