Tandberg Data MSERIES USER, User Manual, Page: 113 / 190

Chapter 7 Running the Demonstration Programs
Running the Demo 5 Program
Tandberg Data M-Series User’s Guide 97
Running the Demo 5 Program
7
The
Demo 5
program causes the robot to pick a randomly selected
cartridge from its magazine slot and place it in another magazine slot on
another level of the stacked library. This test maximizes the use of the
StackLink.
To run the
Demo 5
program:
1
Verify that at least:
• Two library modules are installed in the stack
• One magazine is installed in each library module
• One cartridge is present
2
Access the
Demo Programs
screen (see Accessing the Demo Programs
Screen on page 91).
3
Press the
Up
or
Down
buttons to select
Demo 5
.
4
Press
Select
.
The
Demo 5
program starts. This program continues until you press
the
Stop
button.
5
To stop the program, press
Stop
.
The GUI displays a status screen listing the demonstration program
number, the number of cycles completed, and the status of the test:
pass or fail.
6
Press
Back
to return to the
Demo Programs
screen.
Note:
This program is for multiple library stacks only.