30
Tanco Autowrap 1514-1510
Operator’s manual
10.8 STOP.
On the last revolution, the controller automatically slows, the cutter opens, and it stops at the
right place for next wrapping cycle. Then the cutter closes automatically, and the film is held
tight in the U-formed slot and perforated. The bale is now completely wrapped and ready for
stacking.
EXTRA EQUIPMENT (Standard on 1514’s)
If the machine is equipped with
Rotation after wrapping,
the bale will be rotated till it is in the
right position for off loading, by pushing and holding the Rotate rollers button-button or entering
a rotate after wrap time.
10.9
When the wrapping sequence is ended, Off Load the bale by pressing the Rollers out button.
10.10
After a certain delay the controller is reset and the bale counter is incremented.
10.11 STORAGE
PLACE.
At the storage place the bales should be placed systematically. Start at the right-hand side, and
stack to the left. Lower the machine until the support roller rests on the ground. Push control 7,
ROLLERS OUT,
and the bale will rest on the ground. Drive the tractor carefully away from the
bale. Try to avoid touching the bale with the rollers. The plastic film will now tear off by the
perforation at the cutter. Place the next bale to the left of the first one so that the loose film end
on the last ball will be locked. Then you do not have to leave the tractor cab to fasten the loose
film end. To be sure we recommend that you check that the film ends are securely fastened,
and eventually fasten them a little bit better when you have stacked the bales.
If the machine is front mounted, the bales can be staked upon each other. (See more in chapter
3.0).
