22
Tanco Autowrap 1514-1510
Operator’s manual
The Tanco Autowrap Bale Wrap Controller enables the operator to monitor and control the operation of the
bale wrapper at any stage of the wrapping cycle. The controller is designed for models : 1300EH, 1510EH,
1510T, 1514S, and 1514T rotating-arm type wrappers.
There are 2 operating modes – Automatic and Manual. The automatic mode permits ‘one-touch wrapping’
to ease the workload on the operator. The controller is fully programmable to optimise wrapping
performance. Bale counts are automatically logged in any one of 10 selectable memory stores, in addition
to a grand total memory store.
1.1 IMPORTANT SAFETY INFORMATION!
•
Please read and understand the instructions for using this controller before operating the machine.
•
This controller is fitted with a pushbutton type On/Off Emergency Stop switch. Always ensure the
controller is switched OFF via this switch before attempting any adjustment or maintenance to the
machine.
•
Please follow ALL other safety instructions given in the manufacturers’ Operator Handbook for this
machine.
1.2 Main operating Functions and Display
The principal instrument features and operating functions are shown in figure 1 below.
1. Introduction
2 Operation
Figure 1
Index Bale
(outside auto-
wrap cycle)
Pause bale rotation
(during
auto-wrap cycle)-
Pause wrapping
Release film grip
Fast wrap / Resume wrap
after manually pausing
Bale load
Cut and grip film
Slow wrap
Reverse wrap arm
Select Operating Mode
Start Automatic cycle
(Press STOP switch to stop
cycle e.g. in an emergency,
otherwise press
to
pause the cycle)
Bale unload
Power On/Off
/Emergency Stop
4-way Menu switch to
•
Set No. of wraps
•
Change/reset bale sub-total
•
Access Operator Setup menu
•
Access Technician Setup menu
Add 1 wrap
to current (or
next) bale
A 2-line, 32 character dot
matrix , back-lit display
shows in the normal
operating mode:
•
Current No. of wraps
•
Target No. of wraps
•
Wrapping speed (rpm)
•
Bale total (10 separate
