Tanco 1300 Series, Operator'S Handbook Manual

Page: 35 / 112

Tanco Autowrap - 1310 / 1320
Operator’s Manual
34
8. S & SM CONTROLLER INFORMATION
Total Reset
If for some reason the data in the instrument is corrupted or the display shows ‘PrOg’ then the instrument must be totally reset.
- Switch power off.
- Press and hold all 3 control switches.
- Switch power on.
- Release all switches.
All instrument settings should be returned to the factory-set values. If the display shows ‘PrOg’ again, the instrument may be faulty and must be returned to the manufacturer for inspec-
tion and repair.
Programming Level 2
The 1310 S features Automatic Cut and start operation through the control unit. The 1310 SM also has an autostop feature which holds the joystick in posi-
tion and automatically releases it at the end of the wrap sequence. The settings of these features are programmable in Level 2.
To enter, cut power and power on while holding CAL button. Release after power on. Press and release CAL to advance chevron to next position
To escape from this calibration level, switch power off and on again.
Channel Function Default Range
1 Over speed Alarm* 35 0-99
2 W – Delay after pulse 2 before X 0.5 0-9.9
3 X – C&S Open duration 0.5 0-9.9
4 Y – Delay after Target – 1 before C&S Open 1.0 0-9.9
5 Z – Duration of C&S Open after Target pulse 2.0 0-9.9
6 V – Autostop release delay 0.7 0.0-9.9
[*In normal operation - If the rotation speed in RPM exceeds this number during operation, the alarm will sound for the duration of this condition. Chev-
ron will default to channel 6 and display will flash in this condition. 0.491 Secs Mark and Space. Chevron will revert to channel 1 when speed drops below
overspeed limit].