Tanco 1300 Series, Operator'S Handbook Manual

Page: 29 / 112

Tanco Autowrap - 1310 / 1320
Operator’s Manual
28
1320 Programmable Factors - Technician Level (Pin 1,2,3,4)
Operator Setup Menu
The default settings for the machine are developed by Tanco for optimal operation of the machine. However, the operator can change certain parameters in the ‘Operator Setup’ menu to
take account of operational conditions.
Menu No. Technician Level Default Units Notes
5.01 Sequence 1300x2 Sets Controller Program For Machine Model
5.15 Slow Start Time 2.5 Seconds Time Wrap Arm Runs In Slow Speed at Start Of Wrapping
5.16 C&S Open Time 0.4 Seconds Cutter Opening Time
5.17 C&S Close time 1 3.0 Seconds Cutter Closing Time During Wrapping
5.18 C&S Close time 2 2.0 Seconds Cutter Closing Time At End Of Wrapping
5.23 Bale Indexing Off Not used on 1320
5.24 Reverse Enabled YES Enables / Disables Wrap Arm Reverse Function
5.48 Arm Unfold 2.5 Seconds Time For Wrap Arm To Unfold to Straight Position At The
Beginning Of Wrapping
5.49 Delay to Fold 0.5 Seconds Time After Wrap Arm Speed Changes to Slow Speed
to Wrap Arm Folding (at End of Wrap Cycle)
5.53 1-D Rolls Stop 1.0 Seconds Rollers Intermittent Stop Time For 1 Film Wrapping
5.58 1-D Rolls Rot. 1.3 Seconds Rollers Intermittent Rotation Time For 1 Film Wrapping
5.52 Rot. After Wrap Off Not used on 1320
5.25 RPM Alarm 35 Seconds Maximum Wrapping Arm Speed
5.28 Set Default Sets Controller Back To Its Default Settings
7. EH CONTROLLER INFORMATION