TAMURA NT110, Instruction Manual

Page: 38 / 52

NT110 Instruction Manual (EN)
2D-53-0002680A
29
10-2-3 Two DSP CARD Configuration (Replacing Primary DSP CARD)
* This procedure copies the data stored in the Secondary DSP CARD (Setup and Preset
Program) to a new DSP CARD mounted in the Primary DSP Slot.
If loss of data in the DSP CARD is critical, it is recommended to perform "Backup of NT110 Data"
to provide a means for emergency recovery. For the details of the procedure, refer to Appendix,
Backing Up and Uploading NT110 Data.
1 Turn off the NT110 power.
2 Remove the DSP CARD to be replaced and install a new DSP CARD.
3 Before turning on the NT110 power, press the DSP Change Over button located at
the upper right side of the touch panel to turn it on.
Make sure that the button is depressed and is in the On status. The data stored in the
Secondary DSP CARD will be lost if the button is not depressed and is in the Off
status.
4 Turn on the NT110 power.
While the startup screen is displayed, data is transferred from the Secondary DSP
CARD to the Primary DSP CARD.
5 After the normal screen of NT110 appears, press the DSP Change Over button
again to turn it off.
10-2-4 Two DSP CARD Configuration (Replacing Secondary DSP CARD)
* This procedure copies the data stored in the Primary DSP CARD (Setup and Preset Program) to
a new DSP CARD mounted in the Secondary DSP Slot.
If loss of data in the DSP CARD is critical, it is recommended to perform "Backup of NT110 Data"
to provide a means for emergency recovery. For the details of the procedure, refer to Appendix,
Backing Up and Uploading NT110 Data.
1 Turn off the NT110 power.
2 Remove the DSP CARD to be replaced and install a new DSP CARD.
3 Before turning on the NT110 power, make sure that the DSP Change Over button
located at the upper right side of the touch panel is Off (not depressed).
Make sure that the button is not depressed and is in the Off status. The data stored in
the Primary DSP CARD will be lost if the button is depressed and is in the On status.
4 Turn on the NT110 power.
While the startup screen is displayed, data is transferred from the Primary DSP CARD
to the Secondary DSP CARD.
10-2-5 Operation Check after Replacement
After replacement, activate the DSP CARD to check the audio input/output and operation displays.