TAMURA NT110, Instruction Manual

Page: 31 / 52

NT110 Instruction Manual (EN)
2D-53-0002680A
22
7-2-10 Select Encoder
These are encoders and buttons with functions that switch for each application.
By default, they serve as the HA Gain/Trim encoders.
For some of the assigned functions, you can fine-tune them by rotating an encoder while
pressing it.
7-2-11 Fader
[ 1 ] CUT
Turn on/off Cut. Signals of the channel are muted when Cut
is on.
[ 2 ] APFL
Turn on/off APFL. When it is on, channel signals are sent to
the APFL Bus and interrupts the Monitor specified in the
Config menu.
APFL is turned on and off every time this button is pressed.
In this case, AFL signals are sent to the APFL Bus.
Press and hold this button to send PFL signals to the APFL
Bus while it is pressed.
[ 3 ] SEL
Normally, press this button to recall the Channel Setting
screen on the touch panel and set Select Encoder to the
Channel Setting function.
Channel Setting is a mode for adjusting all the parameters
of a channel. When all the parameters are displayed on the
touch panel, use Select Encoder to adjust the parameters.
* The Sel button serves as a function for specifying a
channel in a special mode other than the above.
[ 4 ] Fader
Motor fader with a 100 mm stroke. Adjust the master
volume of a channel.
[1]
[2]
[3]
[4]