TAMURA NT matrix, Instruction Manual

Page: 32 / 40

NT MATRIX Instruction Manual (EN)
2D-53-00032500
24
9-6 Initializing Internal Data
Perform the following procedure to initialize internal data when required.
If NT MATRIX does not start up due to an internal data error, you may be able to clear the error
using this procedure.
* Data to be initialized by this procedure
- All settings such as the matrixes, and parameters
- Log record data
1 Turn off the NT MATRIX power.
2 Remove DSP CARD to initialize internal data.
Refer to "DSP CARD Installation Method" for detailed procedure.
3 Set "3" and "4" of DIP switch "SW4" of DSP CARD to ON.
4 Attach the DSP CARD with the DIP switch set to the NT MATRIX main unit.
Refer to "DSP CARD Installation Method" for detailed procedure.
5 Turn on the NT MATRIX power.
1 , 2 , 3 , 4
OFF , OFF , ON , ON
ON : Upper
OFF : Lower