DIGITAL TOUCH CONTROLLER (DTC) CONFIGURATIONS
The function of the Digital Touch Controller is dependent on the configuration of the DIP switches and
pin jumper located on the back of the PCB. The jumper pins are located to the left of the RJ45 port, and
the DIP switches are immediately below it.
The jumper is configured by placing it to connect two of the three pins, as shown. *
The DIP switches are configured by switching them to the ON or OFF
position, depending on the switch number. A DIP switch in the ON position
is set away from its number, and towards the side labeled ON, as shown.
MODEL
JUMPER SETTING DIP SWITCH
SETTING
HV2800
(
Kaze
Direct-Mount or
HV2800D Venti
Ducted)
Pin 1-2*
(time delay**)
*Pin 1-2 = 24VDC PWM / Pin 2-3 = 0 – 10 VDC Control Signal
** Time delay allows the door(s) to open before the fan starts
Rear View of the
Digital Touch Controller
RJ45 Jack
Jumper
Dip Switch
Page 15
HV2800 Kaze/HV2800D Venti
Whole House Fan Installation Manual,
HV2800.
4
©
Tamarack Technologies,
Inc All Rights Reserved 20
20
