START-UP AND OPERATION
Before starting this Fan for the first time, verify that:
1. All wiring and connections have been made according to this manual and acceptable wiring standards, and that
this manual and all local codes and standards have been followed in this fan’s installation.
2. No tools or construction debris have been left in, on, or around the fan.
3. The fan’s power cord has been plugged into a ground tested, 120-volt outlet with uninterrupted power.
4. The area in front of the fan’s outlet is as unobstructed as possible, with no object closer than 24” to the face of
the fan.
When running this fan for the first time, make sure to observe it turning on, running at all of its speed settings, and
turning off. Observe from both the attic (to observe the fan(s) itself) and the living space (to observe its damper
door(s)), also verify Timer works at 1 Hour Setting.
As shown, there are four buttons on your fan’s control interface:
When the Digital Touch Controller (DTC) is connected to the fan, and the fan to power, a red LED will illuminate.
See the Power Indicator shown above. If the Power Indicator is not illuminated; double-check the connections
between the fan and the controller, between the fan and the power outlet and power at the outlet.
The
Tamarack Technologies, Inc.
HV2800
KAZE and HV2800D VENTI
has ten speed settings. Turn on the Fan by
touching FAN UP or TIMER UP. Its door(s) will open and there will be a 10 second delay before the fan begins to
operate
.
The fan will start at minimum speed. Green LED’s will illuminate to indicate the speed setting.
If the Fan was turned on by TIMER UP, the timer will be set to one hour and blue LED’s will illuminate to indicate
the timer setting. Press or hold FAN UP to increase the fan’s speed to maximum. Press or hold TIMER UP to
increase the length of time the Fan stays on in one hour increments until the desired time, or the maximum time
of 12 hours, is achieved.
Page 13
HV2800 Kaze/HV2800D Venti
Whole House Fan Installation Manual,
HV2800.
4
©
Tamarack Technologies,
Inc All Rights Reserved 20
20
