TallyGenicom 6306, Maintenance Manual

Page: 38 / 175

6300 Series Maintenance Manual
32
2.3.3.3.7 Keypad
This test verifies that the logic board can receive a signal from each key on the control panel. Once
you have entered the Keypad Test, depressing each key should make its label appear on the
Control Panel Display (i.e., MODE, VIEW, LF , etc.). Exit the Keypad Test by depressing the
CLEAR key three times.
2.3.3.4 Motors
This parameter provides a means for testing individual motor circuits by turning them on or off.
Accessing the Motor Tests:
Step 1. Take the printer offline and place it in Tech Access Mode.
Step 2. With the printer display reading OFFLINE , depress the MENU Key and use the
▲
/
▼

keys to scroll to
TEST
.
Step 3. Press ENTER and scroll (
▲

Key) to Diag .
Step 4.
Press
ENTER
and scroll (
▲

Key) to
Motor
.
Step 5. Press ENTER and scroll (
▲

Key) to either Ribbon or Shuttle. Each Motor Test is
initiated by depressing the ENTER key when the desired selection is displayed.
Motor selections:
Ribbon
Shuttle
Ribbon Pump
Blower
Print Gap
CAUTION: Remove the ribbon before performing the Ribbon Pump test!
The selected test is initiated by depressing the
ENTER
Key. After the motor reaches its assigned
speed the test can be stopped by depressing the ENTER Key again. This sequence may be
repeated until you are satisfied with the operation of the motor. (The Paper Feed Motor may be
tested using the
LF
(line feed) or
FF
(form feed) functions.).