VOIP-500 Series Quick Installation Guide
Copyright 2010 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 5 of 6
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
Use a two conductor, No. 28 to 16 AWG cable size for all auxiliary connections.
Figure 5 Auxiliary Input/Output and Power connectors
VII. Line Level Audio
Connect a 3.5 mm plug to the “Line Level Audio” Connector on the PCB, as shown in the
Figure 2
, to the respective device on the other end, such as the WEBS
®
paging amplifier,
recording device, speaker, etc. The 3.5 mm audio plug is included with the
WEBS-MT/R
,
WEBS-WM
and the
WEBS-PM
installation kits.
After all the field wiring installation, fasten the back box on to the faceplate with the six (6)
hardware nuts and washers.
NOTE:
It is the installer’s obligation to ensure that the wiring should pass through the cable
entry hole at the bottom of the back box. Please exercise caution when reinstalling the back
box and ensure that no cables are crushed during the process.
