TALEX Sp. z o.o.
ul. Dworcowa 9c
77-141 Borzytuchom
tel.: +48 59 821 13 40
e-mail:
www.talex-sj.pl
21
Shredding parts must be replaced after discovering defects, clear signs of wear, blunting of
cutting edges, incomplete beaters or excessive looseness of mounted parts.
Maximum play of shredding parts
Play
Nominal
[mm]
Acceptable
[mm]
Flail
Flail
Axial
transverse
0,3
0,6
Axial
longitudinal
0,2
0,6
Shredding parts should be replaced while observing safety rules..
1.
Use only original and serviceable cutting unit parts.
2.
Each replacement includes a set of parts. It is important to remember about even distribution of
rotating masses and even wear of tools.
3.
Bolt connections should be replaced with new ones each time the parts are replaced, paying attention
to the strength class of the bolt and self-locking nut.
4.
When tightening the screw connection, pay attention to the free, but without excessive play, rotation
of the cutting part relative to the screw axis.
6. Technical inspections, storage and utilization
Daily, after finishing the work with the machine, the shredder should be thoroughly cleaned of impurities and
its technical condition should be checked. Special attention should be paid to the conditio of flail hammers.
Damaged or worn parts must be replaced with new ones. All screw connections should be checked and
loosened connections should be tightened in accordance with the table of tightening torques for screws and
nuts. In the event of defects in the coating, they should be protected with a new layer of paint.
Tightening torques for bolts and nuts
Strenghts
6.8
8.8
10.9
12.9
Metric thread
Tightening torque [Nm]
M5
4,5
5,9
8,7
10
M6
7,6
10
15
18
M8
18
25
36
43
M10
37
49
72
84
M12
64
85
125
145
M14
100
135
200
235
M16
160
210
310
365
M18
220
300
430
500
M20
310
425
610
710
M22
425
580
820
960
M24
535
730
1050
1220
