TALEX Sp. z o.o.
ul. Dworcowa 9c
77-141 Borzytuchom
tel.: +48 59 821 13 40
e-mail:
www.talex-sj.pl
17
mount the PTO shaft, i.e. put the shaft ends on the tractor PTO and PTO of the machine, and secure
against slipping out with the shaft latches.
The shredder should be placed in such a way that the slides are parallel to the ground. To do this, adjust the
upper link.
To adjust the cutting height, unscrew the M12 bolts (marked with number 3 in the figure below) and loosen
the M14 bolts (4). The next step is to put the M12 screws through one of the 4 holes in the side walls of the
body. Moving the screw one hole results in lowering or raising the cutting height by about 11mm.
Fig 3.
Linking the shredder
When moving the machine from the transport position to the working position and vice
versa, it is forbidden to stay in the area of moving elements
.
Work
4.2.
The machine can be started after resting on the ground. It is forbidden to engage the drive
when the machine is lifted above the working surface, not resting on the ground. Lifting the
machine while working is forbidden. Before lifting, disengage the drive and wait for rotation to
stop.
During operation, the rear curtain should be tightened so that it is impossible for it to rise on its
own.
