Takeuchi 12820004, Operator'S Manual

Page: 130 / 182

128
MAINTENANCE
When Required
Replacing the Bucket Teeth and
the Side Cutters
Replace the bucket teeth and the side cutters
when the tooth points or the side cutters are
worn, before the adapter or the bucket is
damaged.
¡
Before performing maintenance or
repairs under the machine, set all
working equipment against the ground
or in the lowermost position.
¡
To prevent unexpected movement,
securely block the working elements
when repairing or replacing the bucket
teeth and the side cutters.
¡
Wear required appropriate equipment
such as safety glasses when using
hammers, as metal fragments or other
objects can fly and cause serious
personal injury.
¡
Do not allow unauthorized personnel
in the work area.
¡
Bucket tooth
Removal
1. Clean the bucket and park the machine in
a flat, safe place where the ground is hard.
2. Set the bottom surface of the bucket flat
and lower it on a block so that the locking
pin (1) can be knocked out.
3. Remove the key, then check that the
bucket is stable.
4. Place a rod against the locking pin (1) and
knock the locking pin out by hammering
against the rod.
The rod should be round and thinner than
the locking pin.
5. Remove the tooth point (2).
Some tooth points (2) are of the type that
are removed by turning (twisting) them
counterclockwise.
The same procedure can be used to
remove the other tooth points.
WARNING
OL1L190
1
2
OL1L200
1
2
OL1L210