Takara Belmont YUME NAGOMI, Installation Instructions Manual

Page: 2 / 20

Request measures to prevent water leakage under the floor and downstairs

Use waterproof flooring materials.

If the floor has an opening, cover the opening when completing the interior finishing (waterproofing).

Install all pipe gaskets.
Before installation
■
■
Installation of pipes
The following are important points to adhere during the installation of pipes.
Read through the details carefully and ensure that the pipes are installed correctly.

When installing this product, ensure that installation of pipes adheres to the instructions outlined in "Precautions during
installation of pipes". Installing pipes without reading through the precautions will mean water may not mix properly, and
a set temperature will not be achieved.

This product is designed for indoor installation. Always install this product indoors.
Precautions during installation of pipes

Do not use pipes made of materials that may introduce rust for the water supply pipe.
In general, VP pipes or other materials specified by regulations in that particular region, are recommended for installation.

In general, Type L deoxidized copper pipes are recommended for hot water pipes.

In general, the same diameter and same pressure is recommended for hot water pipes and water supply pipes.

Always use a reamer to deburr the ends of cut pipes.

Avoid using inverted U-shaped pipes (siphon) as these can cause air to become trapped.

Always connect hot water pipes and water supply pipes after removing all contaminants such as dirt, sand and oil as
these can cause problems.

After connecting the pipes and testing water flow, clean the filter and shower head.

Ensure that the drain pipe is installed at a gradient of 1/50 or more for a diameter of ∅75 or less, or 1/100 or more for
a diameter of ∅75 or more.

Do not connect the hot water pipes and water supply pipes in reverse.
Connecting pipes in reverse will mean the temperature of water cannot be controlled properly by the water taps, which can
cause problems including burns.

Ensure that the hot water pipes from water boilers are only run over a short distance so as to minimize resistance.
Longer pipes can cause fluctuations in temperature and poor hot water delivery.

Always wrap pipes with lagging material after installation is complete.

Water boiler pipes
• In general, the same diameter and same pressure is recommended for main hot water pipes and main water supply pipes.
• Ask professional to install water boiler.

Equipment comes with hair catchers installed.

Avoid the anchor positions when installing the pipe risers.
Be sure to take the necessary precautions to prepare for and prevent possible water leaks.
2
■