Safety Precautions (Must be Obeyed)
Power cords must be replaced by a certified technician
Power cord replacement must be performed by the dealer, Takara Belmont staff, or a technician with equivalent certification.
Consult an electrician for wiring work
Wiring work must be performed by certified personnel. Consult an electrician for wiring work.
Firmly insert the power plug into the outlet
There is a danger of pinching and other physical injury.
Hold by the power plug when unplugging
Do not wash the chair by pouring water on it
Do not connect the earth (ground) to the following objects
• Water pipes
Complete grounding is not possible as hard plastic pipes are widely used.
• Gas Pipes
Connecting to gas pipes can result in an explosion or fire.
• Lightning rods and telephone dedicated grounding wire
Installation precautions
Do not use in an environment where there are electromagnetic interference waves
Precautions when getting in and out of the chair
Precautions for the surrounding area during chair operation
WARNING
2
Be sure to fully insert the power plug into the outlet until reaching the base of the plug. Failure to fully insert the plug or
a similar fault can result in a short circuit or heat generation that causes a fire.
Do not pull the cord to remove the power plug from the outlet. Hold by the power plug at the end of the cord when
removing. Removing the plug by pulling the power cord can damage the power cord, resulting in electric shock or fire.
This chair is an electronic device. Do not sprinkle with water to clean it. Washing in such a manner can result in a
malfunction or electric shock.
Using this chair in an environment where there are electromagnetic interference waves can cause faulty operation. Do
not install the chair near equipment that generates electromagnetic waves such as communication equipment and
elevators. Do not use devices that generate electromagnetic waves (such as mobile telephones) near this chair.
Before and during operation, thoroughly check that there are no bodies or limbs of persons, or possible obstacles in the
operating range of the chair (ranges of seat raising/lowering, backrest reclining/raising, chair rotation, legrest operation)
or nearby. There is a danger of body parts being pinched by the chair, resulting in injury or damage.
Always be sure to lower the chair to the lowest position and lock the rotation when a customer is getting in or out of the
chair in order to ensure safety. Be especially careful when moving a person in a wheelchair in and out of the chair, and
make sure that the wheelchair is not positioned in the operating range of the chair when moving the person. Feet, casters
or other parts contacting the UP/DOWN pedal switch will cause sudden operation of the chair, resulting in injury or damage.
• Installation of this chair must be performed by specialized personnel (personnel from Takara Belmont or Takara
Belmont specified representative).
• The chair must be installed on a perfectly flat and solid floor.
• Installing the chair to a location with an angle of 5°or more can result in the chair tipping over.
Be careful to keep the hands, fingers and other body parts of the customer and user from
touching or getting close to moving parts
Summary of Contents for Luxury MAXIM AB-9500P
Page 2: ......
