Tajfun RCA 480 JOY, Operating Instructions Manual

Page: 27 / 44

7. MAINTENANCE AND SERVICE
Regular machine maintenance ensures reliable operation and long lifetime of the machine.
Any work on the electric circuit can only be performed by a qualified electrician.
7.1. MAINTENANCE PLAN
Turn off the machine and disconnect the PTO shaft when performing service or maintenance.
WHAT? WHEN? HOW?
Check the tension of the cutting
chain
Before each use
See chapter:
Tensioning a cutting chain
Check the tension of the saw belt Every 50 hours of operation
See chapter:
Belt tensioning
Tighten any loose bolts and nuts, as
well as any hydraulic connections
• After first hour of operation
• Every 100 hours of operation
Using appropriate tools
Check the oil level Before each use Visually
Change the oil in the hydraulic
system
After 5,000 hours of operation or
once every two years
See chapter:
Changing the hydraulic system oil
Replace the oil filter cartridge
After first 200 hours of operation
Later, after every 1000 hours of
operation
When changing the oil or if the filter
gauge indicator is in the red zone
Replace the filter cartridge
Change the multiplication gear oil
After the first 50 hours of operation
Later, after every 1000 hours of
operation
When changing the bearings in the
multiplication gear
Drain the oil in a suitable container
through the lower-most plug
and reinstall the plug. Fill the oil
through the upper plug
Cleaning and replacing the air filter
on the saw drive
• Cleaning the filter - daily
• Replacing the filter - every 6
months
See chapter:
Cleaning and replacing the air filter
27
WHAT? WHEN? HOW?
Lubrication
Lubrication point: a, b, c,
At least after every 80 hours of
operation.
Lithium grease.
a
b
c
c