3.5.4 Primary & Secondary Master/Slave UDMA
When set to "Auto" mode, the system will detect if the hard drive supports Ultra DMA mode.
3.5.5 Init Display First
Select "AGP" or "PCI Slot" for system to detect first when boot-up.
3.5.6 IDE HDD Block Mode
This feature enhances disk performance by allowing multi-sector data transfers and eliminates the
interrupt handling time for each sector.
3.5.7 Onboard FDD Controller
Select "Enabled" to activate the on-board FDD
Select "Disabled" to activate an add-on FDD
3.5.8 Onboard Serial Port 1 & 2
Select an address and corresponding interrupt for the first/second serial port. The default value for the
first serial port is "3F8/IRQ4" and the second serial port is "2F8/IRQ3".
3.5.9 UART 2 Mode
Select to activate the Infrared transfer function.
3.5.10 Onboard Parallel Port
Select address and interrupt for the Parallel port.
3.5.11 Onboard Parallel Mode
Select an operating mode for the parallel port. Mode options are Normal, EPP, ECP, ECP/EPP.
3.5.12 ECP Mode Use DMA
Select a DMA channel if parallel Mode is set as ECP, ECP/EPP.
3.5.13 Parallel Port EPP Type
Select a EPP Type if parallel Port is set as EPP, ECP/EPP.
3.5.14 Onboard Legacy Audio
Configuration options: Enabled and Disabled. When Enabled, you can also select some setting for on
board sound. Such as I/O Address, IRQ, DMA…etc
3.6 Power Management Setup
Power management decreases power usage under the pre-defined standby time range.
Figure 3-6. Power Management Setup Screen
CMOS Setup Utility - Copyright ( C ) 1984 - 2000 Award Software
Power Management Setup
ACPI function
Disabled
Item Help
> Power Management
Press Enter
Menu Level >
ACPI Suspend Type
PM Control by APM
S1 (POS)
Yes
Video Off Option
Suspend
à
off
Video Off Method
V/H SYNC+Blank
MODEM Use IRQ
3
Soft-off by PWRBTN
Instant-off
State After Power Failure
> Wake Up Events
Off
Press Enter
