20
M2303-00-P00-805
March 2003
[DATA]
The [DATA] field is only sent if return address information and/or the Group Delay Time data is required to be
sent. Refer to the previous table for details.
Note: Addresses
The default despatcher address is set during the configuration programming. Refer to the
A76 Configuration
section.
Address come in the form of eight ASCII hex characters. Any ASCII character is valid and “
*
“
is the wildcard for any character. e.g. 12
**
5678.
Command Type
Bits 4,5 and 6
Parameters
Bits 0,1 and 2
A76 Action / Response
Control AUX
011
000 : sets the AUX (CTS) signal to ON
001 : sets the AUX (CTS) signal to OFF
010 - 111 : the command will be ignored
If a return address is sent, it is sent in the [DATA]
byte.
A ‘Control AUX ACK’ is sent
back
Examples:
[COMMAND] = 30h = 0011 0000
Sets the AUX (CTS) signal
at the remote radio to ON
and sends a ‘Control AUX
ON ACK’ (B0h) to the
default despatcher address
[COMMAND] = 39,30,30,30,30,30,38,30,30h
39h = 0011 1001 followed by the address
where 30h is ASCII for 0 and 38h is ASCII for 8
Sets the AUX (CTS) signal
at the remote radio to OFF
and sends the message
‘Control AUX OFF ACK’
(B1h) to the return address
00000800
Reset Radio
111
000 : Reset the remote radio only
001 : Reset the radio and initialise the
database with factory settings
010 - 111 : the command will be ignored
no response
Examples:
[COMMAND] = 70h = 0111 0000
Resets the remote radio
[COMMAND] = 71h = 0111 0001
Resets the remote radio
and initialises with values
from the firmware
