10
Single-Stereo Amplifier
Dual-Stereo Amplifier (Bi-Amping)
Standard connection
The right wiring diagram shows
polarity connections for one channel of
a stereo or home theater system.
The outer connection panel and internal dividing
network (crossover) are designed so that separate
sets of speaker cables can be attached to the low-
frequency driver and high-frequency driver portions
of this dividing network. This is called “bi-wiring”.
Bi-wiring can provide several sonic advantages
and considerably more flexibility in power amplifier
selection (Single-Stereo and Dual-Stereo).
• Loosen the terminals and remove speaker
jumpers.
•
Insert the speaker wire for the high frequencies
into the top set of terminals and tighten.
•
Insert the speaker wire for the low frequencies into
the bottom set of terminals and tighten.
Bi-wiring connection (selected speakers only)
Hooking up the wires
DIAMOND Speaker Jumpers
The DIAMOND Speakers are shipped
with the speaker jumpers not installed.
2 jumpers (RED + and BLACK -) are
included in the accessory set.
If you want to use the bi-wiring connection
you do not have to install the jumpers.
If you want to use the standard
connection, install the jumpers as shown
on the figure.
Insert the banana plugs in the upper
terminals – unscrew lower terminals, insert
the spade plugs and tighten the terminals.
