TGWxE1-2G PRI (ISDN) Trunk
Gateways Series for Aeonix User Configuration Manual
8-2
4.
Click the
Basic > System
tab.
For detailed information, see
System Configuration
on page 5-6.
a)
In the
Codec
box, type the required codecs methods to be supported by the gateway.
These codecs must be set due to no default value.
b)
From the
DTMF method
drop-down list,
select
RFC 2833
.
c)
In the
2833 payload type
box, enter 101.
d)
In the
DTMF on-time
box, enter the on time (in ms) of DTMF signal sent from PRI
port. The default value is 100 ms. Generally, the duration time should be set in the
range of 80-150 ms.
For Aeonix US ALARMS system enter 50 ms.
e)
In the
DTMF off-time
box, type 50 ms.
f)
In the
DTMF detection threshold
box, type 32 ms.
g)
Click
Submit
to save changes.
5.
Click the
Basic > SIP
tab.
For detailed information, see
SIP Configuration
on page
5-8
.
a)
In the
Signaling port
box, for Security reasons, it is recommended to change the port
number and not use the default value.
b)
In the
Register server
box, type the Aeonix server IP address.
c)
In the
User name
box, type name. Configure the trunk user name as part of the account
for Aeonix registration (it has no default value).
U
se
Table 5-5
above as a worksheet to make a list of Trunk User Name/Password.
d)
In the
Password
box, enter the password. Configure the trunk password as part of the
account information, which is used for authentication by Aeonix (no default value). It is
