Tadano RCS-FT1, Manual

Page: 11 / 28

M037970E
Radio-control
11
Radio-control
Radio-control
[NOTE]
Even after the radio-control transmitter is turned OFF under the condition where the
radio wave is out of reach, the control unit still remains on in the radio-control mode.
Make sure to confirm that the mode indicator lamp of the control unit indicates “L0” after
the radio-control operation is completed (or after the power of the transmitter is turned
OFF).
1. Preparation for Radio-control Operation
Confirm that each lever is at the following position before starting up the engine.
Each operation lever for extension/winch/elevation/swing/jack ••••• “Neutral”
PTO lever (Switch) ••••• “Disconnected”
Operation mode changes as is shown in the
figure according to the PTO operation,
operation of the radio-control /manual
changeover switch, and power ON/OFF of
the radio-control transmitter.
In addition, an indication on the mode
indicator lamp of the control unit changes as
the figure shows.
1
. Start up the engine and turn PTO to
“Connected (ON)” position.
Confirm that the radio-control /manual
changeover switch is on “Manual” position.
2
. After extending the outriggers, extend the jacks
and set the crane level.
3
. Turn the radio-control /manual changeover
switch to “Radio” position.
When the switch is turned to “Radio” position,
the power of the control unit is turned ON.
M22664E
SPEAKER
SPEAKER
ON
OFF
Radio
Manual
Radio-control/manual changeover switch
M22663
M22666E
PTO
Transmitter
power
Mode indicator
lamp
Radio control/
manual
changeover switch
ON
Manual
operation
Radio-control
operation
OFF 「Manual」
ON OFF 「Radio」
ON ON 「Radio」
Operation mode