Y-7
Y-7
Assembly Adjustment (Traveling Device)
37
WY05-4221E
Y-7 Assembly Adjustment
(Traveling Device)
1. Service brake adjustment
1.1 Adjusting the brake pedal
With the pedal weight causing the roller to contact
the plunger, adjust the bolt until it contacts the
stopper, then use the nut to lock it in place.
1.2 Tightening the cap of reserve tank of service
brake fluid
After bleeding air, pour the brake fluid up to a
required level, and tighten the cap until it stops at
the stopper. At this time, the position of tank body
and cap should be as shown in Fig.1. In addition,
tighten the cap until the mark is aligned with the
mark on tank as shown in Fig.2.
The stopper might be broken when the cap is
tightened too much.
1.3 Check after replacing brake hose
After you replace the brake hoses and so on,
make sure that any contact does not occur
between the hoses and the structures in any
situation. Check it with moving suspension (up
and down) and steering (right and left.)
In addition, make sure that any hose is not twisted
forcibly.
2. Accelerator adjustment
2.1 Accelerator pedal
Summary of Contents for GR-300EX-3
