Tactile Medical Flexitouch Plus, User Manual

Page: 16 / 70

27 28
Customer Service Toll Free: 833.3TACTILE (833.382.2845)
3.2 Selecting Your Settings
Follow the steps outlined below to select the settings prescribed by
your healthcare provider.
NOTE:
Your controller unit will arrive programmed with your prescribed
treatment saved as the first preset. You may not need to modify the
preset program(s) unless instructed by your healthcare provider. The
controller unit can, however, store up to three treatment therapies, and
will automatically recall and highlight the last performed treatment.
Turn the controller unit ON.
1. Turn the controller unit on by pressing the
button located
in the upper right corner on the front panel (Figure 3.2.a.).
Select and start your treatment session.
2. Your prescribed treatment program will be saved as the first
preset on the home screen, and will be highlighted in blue
when the controller unit is turned ON. To begin your prescribed
treatment session, select the
button found on the right-hand
side of the controller unit. Your treatment session will begin, and
the time remaining will be displayed.
Figure 3.1.a. Power Adapter
A plug adapter may
be necessary for use
outside the U.S.
2800_Control_Panel_KL.pdf 1 12/9/16 1:50 PM
On/Off
Back
Up
Down
Enter
Connector
Number
If you are prescribed a supplemental program, it will be saved
as the second preset on your controller unit. To switch to the
second preset and run the treatment program, press the
arrow button until the second preset is highlighted in blue. Once
highlighted, select the
button to begin the supplemental
treatment. Your treatment session will begin, and the time
remaining will be displayed.
NOTE:
You may PAUSE TREATMENT for up to 15 minutes at any point
during a treatment session by pressing the button. After that time,
the controller unit will automatically shut off, requiring you to restart
your treatment session. To resume your treatment, make sure the
RESUME TREATMENT option is highlighted in blue, and press the
button. To stop treatment, press the arrow button to select STOP
TREATMENT and select .
Selecting or programming a new treatment.
Figure 3.2.a. Controller Unit Front Panel