5.4.2
Connecting the fresh water station to the power supply
DANGER!
Danger due to electric current!
When working with power cables, there is an imme-
diate danger of severe, or even fatal, injury due to
electric current.
– Ensure that the cable is not live when performing
installation work.
– Only have work on electric cables performed by
an electrician.
– Never connect voltage to open cables.
– Before connecting the cable to voltage, ensure
that no persons are near electric cables.
The station is wired ready for connection.
Personnel:
n
Electrician
1.
Ensure that there is a junction box and it is protected from
short circuit by means of a residual current device.
2.
Plug the connector plug for the station into the socket pro-
vided.
5.5
Connecting optional equipment
5.5.1
Installing the sensor in the tank for two-zone stratification
Personnel:
n
Heating and sanitary technician
1.
Connect the sensor to the buffer tank (middle).
2.
Connect the sensor to the controller for the fresh hot water
station in accordance with the instructions for the controller
Chapter 1.2 ‘Other applicable documents’ on page
5.5.2
Connecting cascading
Personnel:
n
Heating and sanitary technician
Prerequisite:
n
Cascading and the zone valves have been installed in accordance
with the hydraulic diagram.
Connect the zone valves for cascading in accordance with the
instructions for the controller.
TACOTHERM FRESH PETA 2 / PETA 2 X
Assembly and installation
V02.2020 11/2020
Item no. 215747
EA no. 1329
Operating instructions
37
