33
Special functions
6.19. - Sensor calibration
Caution
Caution
May only be started by a specialist during commissioning! Incorrect settings may cause malfunctions.
Starting the commissioning help guides you in the correct order through the basic settings necessary for commissioning, and
provides brief descriptions of each parameter in the display.
Pressing the “esc” key takes you back to the previous value so you can look at the selected setting again or adjust it if desi-
red. Pressing the “esc” more than once takes you back to the selection mode, thus cancelling the commissioning help.
6.20. - Commissioning
May only be started by a specialist during commissioning! Observe the explanations for the the individual
parameters in these instructions, and check whether further settings are necessary for your application.
Deviations in the temperature values displayed, for example due to cables which are to long or sensors which are not positi-
oned optimally, can be compensated for manually here. The settings can be made for each individual sensor in steps of 0.8°C
(temperature) resp. 0.2% of the measuring range of the VFS / RPS sensor (
fl
ow rate / pressure) per step.
Offset Sensor Settings range: -100 ... +100 / Default setting: 0
Caution
All of the settings that have been made can be reset, thus returning the controller to its delivery state.
6.21. - Factory settings
The entire parametrisation, analyses, etc. of the controller will be lost irrevocably. The controller must
then be commissioned once again.
