English
English
35
■
Displayed IP address, net mask, gateway, and DNS information is
not correct
●
All values on the screen are zeros
This is likely due to a wiring issue between the remote
controller and the router. Recheck the following items.
Check Items
●
Make sure the LAN cable is securely connected to the
connector in the remote controller.
●
Make sure the LAN cables are connected to the proper
ports.
●
The IP address and net mask appear but the
gateway and DNS information does not appear
This is likely due to a wiring issue between the remote
controller and the router. Recheck the following items.
1. Check the configuration of your network settings.
2. Manually enter the gateway and DNS information used
in your network environment.
●
You can choose to keep the address and other
information automatically populated or you can
manually enter the IP address, net mask, and other
necessary network information applicable to your
network environment configuration.
●
To manually configure these settings, refer to "Manual
configuration of network settings" (Page 36).
■
Troubleshooting r-10 errors
●
LAN cable is connected
This is likely due to a wiring issue between the remote
controller and the router. Recheck the following items.
Check Items
●
Make sure the LAN cable is securely connected to the
connector in the remote controller.
●
Make sure the LAN cables are connected to the proper
ports.
Press [RETRY] to reattempt automatic configuration of
network settings.
●
LAN cable is not connected
Press [BACK] to cancel the reattempt of automatic
network settings configuration.