SW48-M
13
With machine sitting on a flat, level surface similar to the type to be swept, hold on to the Brush
Up-Down Lever, remove the Brush Adjustment Transport Pin, and then ease the Brush Up-
Down lever to the appropriate down (rearward) position. (Fig. 1) You may replace the transport
pin into the proper hole when machine is in the "Down" position.
Adjust the brush height by turning the Brush Height Adjusting Screws. (Fig. 1) The brushes,
when properly adjusted, should make a light sweeping pattern 2 to 3 inches wide and uniform
along the brush center line. (see Fig. 2) Too much pressure on the brushes will cause excessive
wear and reduce sweeping efficiency.
Fig.2
Fig. 1:
1.
Brush Adjustment Transport Pin.
2.
Brush Height Adjustment Screw
(x2).
3.
Brush Up-Down Lever in "Up"
(forward) Position.
2
1
3
Summary of Contents for SWEEP-N-CLEAN SW-48-A
Page 1: ......
Page 24: ...SW48 M 23 WIRING DIAGRAM 1 SW48 M Sweep N Clean...
Page 27: ...SW48 M 26 DECAL PLACEMENT SW48 M SWEEP N CLEAN...