T.I.P. SWEEP-N-CLEAN SW-48-A, Operator Instructions Manual

Page: 13 / 33

SW48-M
12
SET-UP
SW48-M SWEEP-N-CLEAN
CONNECTION TO TOW VEHICLE
If your Sweep-N-Clean came delivered on a pallet, first remove machine from pallet.
Connect the pin-type hitch to your tow vehicle using a pin that is the appropriate diameter, and
secure with a safety clip to ensure pin does not come out during operation.
CAUTION!
Be sure that the tow vehicle has sufficient power and braking capacity to safely pull the Sweep-
N-Clean before use.
ELECTRICAL CONNECTION
The Sweep-N-Clean utilizes the 12v electrical supply from the tow vehicle to operate the electric
clutch and to open and close the clamshell hopper cover.
Connect the alligator clips from the machine to the battery of the tow vehicle, being sure to
connect the red clip to the positive side of the battery, and the black to the negative. Be sure that
clips and wires are properly secured so they will not vibrate off during operation.
CAUTION!
Avoid direct contact with the battery terminals and the un-insulated portion of the alligator clips.
Electrical shock could result.
Unroll cord and switch pendant. Locate switch pendant near operator on tow vehicle, and secure
in place.
BRUSH HEIGHT ADJUSTMENT
Properly adjusted brush height will provide you with the best sweeping action and the longest
bristle life. It is necessary to do this adjustment before using the Sweep-N-Clean for the first
time, and periodically as routine maintenance.