INSTRUCTION
MANUAL
24
9.4. FINE ADJUSTMENT OF THE COLLARING TOOL
To obtain appropriate joint clearance, a fine adjustment is needed occasionally.
1. Extend the forming pins to the collaring position.
2. Note the position of the hash mark on the cylindrical cover in relation to a mark on the
cover plate.
3. Loosen the adjustment screws for half a turn on the cover plate.
4. Rotate the cover plate relative to the cylindrical cover clockwise / counter-clockwise to
increase and decrease the diameter of adjustment, respectively. One notch on the cover
plate equals to 0.5mm / 0.02” on the forming pin span.
9.5. ANNEALING OF THE PILOT HOLE
Annealing a part or the entire pilot hole before collaring is necessary for certain collars.
Please refer to the PLUS 115 capacity and instruction chart for more detailed information
on the annealing.
1. Anneal the area where outlet is to be
formed to a dull red. The area will remain
annealed even when cool. It is not necessary
to form the outlet on hot tube!
Summary of Contents for PLUS 115 CU
