T-Drill PLUS 115 CU, Instruction Manual

Page: 14 / 65

INSTRUCTION
MANUAL
14
8. TAKING THE MACHINE INTO OPERATION
Creating a collar with your PLUS 115 and completing the joint is simple. This is a new
and innovative technology and therefore it is strongly recommended that you read the
following instructions carefully and then practice a few times on a piece of scrap tubing.
The T-DRILL T-65 that is used as a power source for the PLUS 115 and for the drilling of
the pilot hole requires the following changes before it is put into use:
1. Replace the chuck ring of the
T-65. The required chuck ring is identified
from the hole drilled into it. Snap ring pliers
are needed to do this.
2. Using the hex key provided, replace the
tube support with the tilt rod assembly.
When changing to the tilt rod assembly use
the provided shorter screws. The drilling
depth scale is placed on the opposite side
from the cord of the T-65. Do not let the push
rods rotate when loosening or tightening the
screws at the end of the push rods. Use pliers
and cover the push rod with a workshop rag.
That prevents damage to the surface of the
push rods.
Before using it, check that the power supply voltage matches the rated voltage specified
on the device.
NOTE!
¨ Before forming any tee always make sure that the pipe is completely
drained and that it is not under pressure.