T+A Elektroakustik AMP 8, User Manual, Page: 25 / 36

25
Loudspeaker
and signal
cables Loudspeaker cables and signal cables (inter-connects) have a significant
influence on the overall reproduction quality of your sound system, and
their importance should not be under-estimated. For this reason

recommends the use of high-quality cables and connectors.
Our accessory range includes a series of excellent cables and
connectors whose properties are carefully matched to our speakers and
electronic units, and which harmonise outstandingly well with them.
For difficult and cramped situations the

range also includes special-
length cables and special-purpose connectors (e. g. right-angled
versions) which can be used to solve almost any problem concerning
connections and system location.
Care of the
unit
Always disconnect the unit from the mains supply before cleaning it.
The surfaces of the case should be wiped clean with a soft, dry cloth
only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no short-circuits
at the connections, and that all cables are plugged in correctly.
Storing the
unit If the device has to be stored, place it in its original packaging and store it
in a dry, frost-free location. Storage temperature range 0...40 °C
Safety notes
For your own safety please consider it essential to read these operating
instructions right through, and observe in particular the notes regarding
setting up, operation and safety.
Installation Please consider the weight of the device. Never place the device on an
unstable surface; the machine could fall off, causing serious or even fatal
injury. Many injuries, especially to children, can be avoided if the
following simple safety precautions are observed:

Use only such items of furniture which can safely bear the weight of
the device.

Ensure that the device does not project beyond the edges of the
supporting furniture.

Do not place the device on tall furniture (e.g. bookshelves) without
securely anchoring both items, i.e. furniture and device.

Explain to children the hazards involved in climbing on furniture to
reach the device or its controls.
When installing the unit on a shelf or in a cupboard it is essential to
provide an adequate flow of cooling air, to ensure that the heat produced
by the unit is dissipated effectively. Any heat build-up will shorten the life
of the unit and could be a source of danger. Be sure to leave free space
of 10 cm around the unit for ventilation.
If the system components are to be stacked then the amplifier must be
the top unit. Do not place any object on the top cover.
The unit must be set up in such a way that none of the connections can
be touched directly (especially by children). Be sure to observe the notes
and information in the section
'Installation and Wiring' .